first combination manipulation
6 posts
• Page 1 of 1
Ive lurked for a while, and read a lot of documentation, so i decided to try my first manipulation. after some confusion, i managed to make the first graph, but something is off about it. the only indications i see are showing the opposite of a gate, they actually get wider! I received advise to isolate which wheel was indicating around 75-85 on RCP as that is the only thing that remotely resembles a gate, so thats what ill be doing next. In the meantime if anyone can point out my mistakes, or point me on the right path with this wonky graph, i would greatly appreciate it.
Re: first combination manipulation
Welcome,
Looks to me as if your Left and Right contact points are reversed.?
Looks to me as if your Left and Right contact points are reversed.?
Re: first combination manipulation
i like the look of 68 ish, either fine dial around there or re-graph AWR and see what that throws up.
Re: first combination manipulation
as a test I would try 15, 62, 85 (run through the 9 different combo's that they could be) just to see what would happen. (should only take a min or 5 to try it)
(17:44:28) HAL 9000 Sez: LockSport is full of children who throw fits because low priced low security products sold in discount department stores do not meet their arbitrary expectations.
Re: first combination manipulation
ignore my suggestion of 68, i've just looked properly at your scale and realised why your graph looks weird, Anarchy_won has it spot on numbers wise. it's usual to plot low numbers at the bottom of the axis going up towards the top of the page. you've created a kind of mixed up negative graph, if you cut your piece of paper in half and stick it back together with the 2 graph lines swapped over you'll have a good looking graph which will read right.
Re: first combination manipulation
Very good graph for a first attempt. I agree usually the graph represents the area between contact points, so you should make the new ones with 5 on top and 97 at bottom.
I'd amplify readings around 15, let's say between 12 and 18, to find this gate center.
Then I'd perform a hi-low test to see which wheel it's on.
Then I'd check the other interesting areas of the graph... but first tell us what happens with this quick and easy test.
Cheers
I'd amplify readings around 15, let's say between 12 and 18, to find this gate center.
Then I'd perform a hi-low test to see which wheel it's on.
Then I'd check the other interesting areas of the graph... but first tell us what happens with this quick and easy test.
Cheers
6 posts
• Page 1 of 1
Return to Safes, Strongboxes & Combination Locks
Who is online
Users browsing this forum: No registered users