.:: Keypicking :: Anything And Everything For Locksmiths, Hobbyist Lock Pickers, Locksport, Lock Picking, lockpicks, cutaways and Security. Simply The Best Lockpicking Forum Around!

Posted: **Thu Jul 07, 2011 4:59 am**

I got given a Lockwood 234/45, with an interchangable core, been good fun, just wondering how one would go about removing the shackle? There's a small hole at the bottom, I put a screwdriver in it but couldn't feel anything, I assumed it was just for oil.

Any ideas?

Posted: **Thu Jul 07, 2011 6:30 am**

I have no experience with Lockwoods. If they are anything like the Abus padlock the back end of the cylinder turns a cam inside the lock. Turning that cam either too far, or in the opposite direction (with the cylinder out) will release the shackle.

Posted: **Thu Jul 07, 2011 6:55 am**

I don't think the small hole is for oil, probably for moister removale (SP ? )

Posted: **Thu Jul 07, 2011 6:59 am**

hi mate 234/45 you need to pull the cam out of the lock and the 2 balls will fall out the shackle will just pull out aswell and with 234B/45 you have a small hole on the back of the padlock you put a small allen wrench in unscrew the pin and pull the shackle out hope this helps if need be i can prob do a quik vid for ya

Posted: **Fri Jul 08, 2011 12:16 am**

Thanks Bezza,
I've just checked, it's a 234/45, not the 234B/45.

If you have time to make a video that would be great, I've been Googling to no avail except for seeing a jig that does it on some padlocks.

.:: Keypicking :: Anything And Everything For Locksmiths, Hobbyist Lock Pickers, Locksport, Lock Picking, lockpicks, cutaways and Security. Simply The Best Lockpicking Forum Around!

Removal of Padlock Shackle

Removal of Padlock Shackle

Re: Removal of Padlock Shackle

Re: Removal of Padlock Shackle

Re: Removal of Padlock Shackle

Re: Removal of Padlock Shackle