.:: Keypicking :: Anything And Everything For Locksmiths, Hobbyist Lock Pickers, Locksport, Lock Picking, lockpicks, cutaways and Security. Simply The Best Lockpicking Forum Around!

I finally got my 5 pin in pin Mul T Lock Classic picked yesterday after 2 long days of frustration i used a customized Klom dimple feeler pick(still workin out the kinks) it takes me a good amount of time to pick this lock still so any advice would be appreciated. Heres a pic of the finished product

good luck getting yer time down..=)
i nailed my MTL interactive,but can't seem to get my time down.
very tricky.

these are easilly picked with a small half diamond. I use southord small half diamond

Apply good tension and slide your pick in sideways just brushing the tips of the pins til you reach a hard one.
loosen tension and slide in above it, twist half diamond.

repeat feeling for binding pins.

eventually the plug will shift a good few degrees.

all thats required now is a tickle over the pins to set the inner pins. This bit is very easy.

Iv picked loads of these now and only problem i have encountered is high lift back pins. To overcome this you need to file some of the pick shaft away so that when your twinsting to set a back pin you arent lifting any front ones.

If that makes sense. The ideal tool would be piano wire with a half diamond end.