the lockpickkid wrote:cool Hintz that would be awesome, the key I used did fit the keyway, I just couldn't mill it thin enough to fit without grinding through to the inside of the key.
That's ok mate, I didn't mean to rain in on your parade. I used to set about my locks with a dremel and totally f*ck them up
but the main thing was that it worked right there and then....
With the machine I can work to such minute tolerances and go at my own pace with a cut..... the dremel days was a one time cut, as in 'Do it once, and in one swoop'. All good fun though!
L0ckp1cker, I will surely be needing a few keys if the lads want one each. Let me get a prototype done tomorrow and we'll go from there.
Totally a non profit thing by the way, if postage is covered, I'm happy. (Obviously I'm only looking to do about 10-20, I don't want to supply the world.... just you lot here.
Cheers,
Spence