total 100% noob trying to open a safe. Hi and HELP !!!
I'm wondering why nobody put a 5 foot diameter degree wheel onto the knob to begin with. I think I'd be able to understand 360 degrees and 60 minutes of a degree much easier than I can 1/8 increments of a 100 scale ... or should I say 0 to 99 scale ?
After AWL and AWR trial runs through a couple of first graphs I do not feel like I see where to magnify. There seem to be several places but I get a lot of discrepancy when trying AWL or AWR.
I took the AWR 1st graph a step further to determine which wheel by going 10 high and then 10 low. The 2nd graph was basically a straight line ! Only one deviation on the right contact point and regions similar to the 1st graph on the left contact point. I have yet to complete an entire graphing exercise ending with trying different third graph dial numbers.
Am I being too impatient ? It's S&G 3670 I believe, Black face knob with the S&G logo. Numbers on a silver ring are exposed all the way around. Should I post my troubles in another part of the forum instead of introductions ?