### Hello! Newbie with a S&G 6730

When I went for wheel 1-2 ar it was a flat line. The safe was dead.. I picked up very faint drop at 37 and 5. So I assumed 37 or 5 would have to be the 1 or 2nd wheel. In both cases 37 and 5 the high low test came through very faintly on wheel 2. So I tried all 200 combinations of ?-37-20 and ?-5-20. Non of them worked. I also tried assuming my high low was wrong and did 37-?-20 - 5-?-20 all 200 combinations. Also with no success.

Did I miss a step? Could I be doing something with the middle manipulation wrong. Also my contact points vary when searching for the 3rd number. I would think if I had the proper two numbers on 3-2 then that would be the starting point for the contacts for the last wheel and it should only get smaller from there. But it doesnt. It jumps bigger and smaller even with the same 3-2 wheel numbers.

This is my first safe attempt but I have very good eyes and very steady fingers and I feel like I am doing things correctly. However it's very possible that I am not. Please help. Thank you.