Slick Pick 2.0
New things:
Lanyard/keyring hole.
Internal Tension wrench.
Slot Resizing so the button doesn't end up at the very bottom of the pick when closed.
I think this is the last major update, from here I'm just going to do a few little tweaks. One of those tweaks is to remove the lettering off the front and back. Cause one of the sides has to be the print surface, it's no good for detail. I had "Slick pick" Written on the back in a cool font. But when that side is printed down, the lettering doesn't show up, cause of the heated bed. If I print that side up, the face of the pick is smooth cause of it being the down side, and that's ok. But the track almost closes up and takes a lot of filing to correct. Also The font I used when printed looks like it says "Suck Puck" cause the l and i blen together to make a U.
So Ver 2.1 Will be basically this, with no lettering. Anyways here's what they look like. I like that it fits a tension wrench in the handle, so now all you need is this one thing on your key chain. Kind of an EDC pick.
Video For a better look:
https://www.youtube.com/watch?v=9ATX22AY9cM