Tublar duplicator-on the cheap
It looks and works similar to the HPC tool. It features a dial to set the
spacing (cut position) and a dial for the depth. It is designed for standard center, 7 pin tubular configuration only. According to the distributors the tool can handle dead pins and both standard bore and smaller bore (7.5 mm ) center posts dia.
I cut a 7 pin key, using a brass blank, in under five minutes.
Being hand operated, it it definitely not for volume production, but
I think it would be great as a backup cutter for the shop or
in the mobile van- takes little if any bench space.
It comes with a depth gauge and Nylon carry case. At about $69 US, (plus freight/taxes) I think it is a good deal and a good deal cheaper than the HPC model (about $300 if I recall correctly).