Reviewing Technical Entry's 'Sensitive Pry-bar's'
21 posts
• Page 2 of 2 • 1, 2
10ringo10 if you have a spare piece of steel and a template , could you be persuaded to post them to me , ahem , will trade !
Open Sez Me !
Re: Reviewing Technical Entry's 'Sensitive Pry-bar's'
This is it,im surprised how much control you have with this bar...only had one steel bar nozza and i went with mechs sizes or close to it as i could from the vid.....no template.
You do not have the required permissions to view the files attached to this post.
Re: Reviewing Technical Entry's 'Sensitive Pry-bar's'
Ya $26.00CAD for (2) is a little out of my budget. I'll wait a few weeks and see what happens.
-= Lumpy =-
Re: Reviewing Technical Entry's 'Sensitive Pry-bar's'
i agree but they are probably worth it in the long run ...very nice little tool.
Re: Reviewing Technical Entry's 'Sensitive Pry-bar's'
10ringo10 , is 1.1 mm the thickness ? will hunt out that gauge and " CONSTRUCT A MIGHTY WEAPON"
Open Sez Me !
Re: Reviewing Technical Entry's 'Sensitive Pry-bar's'
well the three sizes were 1mm x 1.2 x 1.27 thickness or gauge.
21 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: No registered users